[High Quality Exam Dumps] Cisco 200-125 Dumps Latest PDF Training Materials And Youtube Free Update
adminLatest Cisco CCNA 200-125 dumps pdf questions and answers free download. Prepare for Cisco 200-125 exam test with latest Cisco CCNA 200-125 dumps pdf training materials and study guides. https://www.lead4pass.com/200-125.html dumps pdf practice files. Get the best Cisco CCNA 200-125 dumps pdf and vce training resources from lead4pass, pass Cisco 200-125 exam test easily.
Latest Cisco 200-125 dumps pdf files free download: https://drive.google.com/open?id=0B_7qiYkH83VRSnZDMkVUWDJzLWM
Latest Cisco 200-105 dumps pdf files free download: https://drive.google.com/open?id=0B_7qiYkH83VRS3BsT2duT3pTSlU
Vendor: Cisco
Certifications: CCNA
Exam Name: CCNA Cisco Certified Network Associate CCNA (v3.0)
Exam Code: 200-125
Total Questions: 966 Q&As
QUESTION 1
A network administrator is verifying the configuration of a newly installed host by establishing an FTP connection to a remote server. What is the highest layer of the protocol stack that the network administrator is using for this operation?
A. application
B. presentation
C. session
D. transport
E. internet
F. data link
Correct Answer: A
QUESTION 2
Three switches are connected to one another via trunk ports. Assuming the default switch configuration, which switch is elected as the root bridge for the spanning-tree instance of VLAN 1?
A. the switch with the highest MAC address
B. the switch with the lowest MAC address
C. the switch with the highest IP address
D. the switch with the lowest IP address
Correct Answer: B
QUESTION 3
Which of the following describes the roles of devices in a WAN? (Choose three.)
A. A CSU/DSU terminates a digital local loop.
B. A modem terminates a digital local loop.
C. A CSU/DSU terminates an analog local loop.
D. A modem terminates an analog local loop.
E. A router is commonly considered a DTE device.
F. A router is commonly considered a DCE device.
Correct Answer: A,D,E
QUESTION 4
Which three statements about static routing are true? 200-125 dumps (Choose three.)
A. It uses consistent route determination.
B. It is best used for small-scale deployments.
C. Routing is disrupted when links fail.
D. It requires more resources than other routing methods.
E. It is best used for large-scale deployments.
F. Routers can use update messages to reroute when links fail.
Correct Answer: ABC
QUESTION 5
Refer to the exhibit. The two connected ports on the switch are not turning orange or green. What would be the most effective steps to troubleshoot this physical layer problem? (Choose three.)
A. Ensure that the Ethernet encapsulations match on the interconnected router and switch ports.
B. Ensure that cables A and B are straight-through cables.
C. Ensure cable A is plugged into a trunk port.
D. Ensure the switch has power.
E. Reboot all of the devices.
F. Reseat all cables.
Correct Answer: BDF
QUESTION 6
Two features of the extended ping command? (Choose two.)
A. It can send a specific number of packet
B. It can send packet from specified interface of IP address
C. It can resolve the destination host name
D. It can ping multiple host at the same time
Correct Answer: AB
QUESTION 7
In an Ethernet network, under what two scenarios can devices transmit? (Choose two.)
A. when they receive a special token
B. when there is a carrier
C. when they detect no other devices are sending
D. when the medium is idle
E. when the server grants access
Correct Answer: C,D
QUESTION 8
Which command can you enter to display the operational status of the network ports on a router? 200-125 dumps
A. show interface switchport
B. show ip interface brief
C. show running-config interface fastethernet 0/1
D. show interface status
Correct Answer: B
QUESTION 9
Which Layer 2 protocol encapsulation type supports synchronous and asynchronous circuits and has builtin security mechanisms?
A. HDLC
B. PPP
C. X.25
D. Frame Relay
Correct Answer: B
QUESTION 10
A network administrator is troubleshooting the OSPF configuration of routers R1 and R2. The routers cannot establish an adjacency relationship on their common Ethernet link.
The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2. Based on the information in the graphic, what is the cause of this problem?
A. The OSPF area is not configured properly.
B. The priority on R1 should be set higher.
C. The cost on R1 should be set higher.
D. The hello and dead timers are not configured properly.
E. A backup designated router needs to be added to the network.
F. The OSPF process ID numbers must match.
Correct Answer: D
QUESTION 11
A network interface port has collision detection and carrier sensing enabled on a shared twisted pair network. 200-125 dumps From this statement, what is known about the network interface port?
A. This is a 10 Mb/s switch port.
B. This is a 100 Mb/s switch port.
C. This is an Ethernet port operating at half duplex.
D. This is an Ethernet port operating at full duplex.
E. This is a port on a network interface card in a PC.
Correct Answer: C
QUESTION 12
In which three ways is an IPv6 header simpler than an IPv4 header? (Choose three.)
A. Unlike IPv4 headers, IPv6 headers have a fixed length.
B. IPv6 uses an extension header instead of the IPv4 Fragmentation field.
C. IPv6 headers eliminate the IPv4 Checksum field.
D. IPv6 headers use the Fragment Offset field in place of the IPv4 Fragmentation field.
E. IPv6 headers use a smaller Option field size than IPv4 headers.
F. IPv6 headers use a 4-bit TTL field, and IPv4 headers use an 8-bit TTL field.
Correct Answer: ABC
Read more: https://www.lead4pass.com/200-125.html dumps training materials and study guides update.
Watch the video to learn more: https://youtu.be/nF4Ul2viODM